Copyright © 2011 Thomas M. Eastep
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, with no Front-Cover, and with no Back-Cover Texts. A copy of the license is included in the section entitled “GNU Free Documentation License”.
2020/02/16
Table of Contents
LXC (http://lxc.sourceforge.net/) is a set of user-space tools for managing the container capabilities that have been in the Linux Kernel since 2.6.27.
This short article describes how I've implemented LXC here at shorewall.net, with emphasis on the networking and firewall aspects.
The following diagram shows the network at shorewall.net in the spring of 2011.
As shown in that diagram, the LXC containers are bridged to br0. Here are the relevant configuration entries.
/etc/network/interfaces:
# # LXC bridge # auto br0 iface br0 inet static bridge_ports none bridge_fd 0 address 70.90.191.121 broadcast 0.0.0.0 netmask 255.255.255.255 post-up ip route add 70.90.191.124/31 dev br0 iface br0 inet6 static address 2001:470:b:227::41 netmask 124
/etc/lxc/mail.conf
lxc.network.type=veth lxc.network.link=br0 lxc.network.flags=up lxc.network.ipv4=70.90.191.124/29 lxc.network.ipv6=2001:470:b:227::42/124 …
/etc/lxc/server.conf
lxc.network.type=veth lxc.network.link=br0 lxc.network.flags=up lxc.network.ipv4=70.90.191.125/29 lxc.network.ipv6=2001:470:b:227::43/124 …
Note that I have subnetted 2001:470:b:227::/64 with a /124 (2001:470:b:227::40/124) assigned to the bridge. To make those addresses accessible from the LOC zone, the following entries are required in /etc/shorewall6/proxyndp:
#ADDRESS INTERFACE EXTERNAL HAVEROUTE PERSISTENT 2001:470:b:227::41 - eth1 Yes Yes 2001:470:b:227::42 - eth1 Yes Yes 2001:470:b:227::43 - eth1 Yes Yes
The entries in the LXC .conf files are expected to configure eth0 in
the LXC containers; they do, sort of. In both of the
containers, no ipv6 default route was assigned. I corrected that by adding
this entry in /etc/sysctl.conf
in both
containers:
net.ipv6.conf.all.forwarding=0
I then added this stanza to /etc/radvd.conf
on
the host:
interface br0{ AdvSendAdvert on; MinRtrAdvInterval 300; MaxRtrAdvInterval 505; AdvDefaultLifetime 9000; route ::/0 { AdvRouteLifetime infinity; }; };
Curiosly, LXC gives container mail's eth0 this somewhat odd configuration, and fails to add a default ipv4 route:
14: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 4e:56:66:11:3c:6b brd ff:ff:ff:ff:ff:ff
inet 70.90.191.124/29 brd 70.90.191.120 scope global eth0
inet6 2001:470:b:227::42/124 scope global
valid_lft forever preferred_lft forever
inet6 fe80::4c56:66ff:fe11:3c6b/64 scope link
valid_lft forever preferred_lft forever
So in that container's /etc/rc.local
, I also
have:
ip route add default via 70.90.191.121
With the exception of the entries in
/etc/shorewall6/proxyndp
. the Shorewall and
Shorewall6 configurations are fairly conventional three-interface setups.
In both configurations, the interfaces
file entry for
br0 has the routeback
option specified.